Then back to the Arduino app and I can see it as COM6 in the Tools menu and having done the boards.txt change, I can select it as a Mega ADK. I installed the driver by browsing PC in Dev Man and at this point it shows up as COM6. This switched the Mega ADK out of DFU mode and a new serial driver appeared in Dev Man (again without a driver). of course this still could be the wrong HEX file, given my upload issues.Īt this point I chose the Start Program button on the bottom right of Flip. HEX file I had downloaded from SourceForge (using RAW) - note the combined DFU/Serial file won't work, only the SerialUSB. Then in Flip I think I just selected USB and it un-greyed all the lower screen allowing you to chose things in the Run panel and select a HEX file. I started with it showing as a Atmega8u2 device without the driver installed (! in Dev Manager).Īfter installing flip, I installed the driver for the Atmega8u2 by browsing for it on PC in Dev Man. hex file, but it certainly got me further, as the RX light is now flashing and it is set to COM6 on the PC and detected by the Arduino app. I should say I still haven't got past the timeout when uploading, so I might have flashed the wrong. I'll have to remember from memory as once I did the Start Program it switched out of DFU mode and I'm not sure how to switch it back.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |